easyTrack, Getting started
14(14)
Thrane & Thrane-001
Rev. PA5
26. February 2002
© Thrane & Thrane. Commercial in Confidence
For further detailed information about Event Programming refer to TT3026L/M
easyTrack Transceiver Software Interface Reference Manual (TT-98-116080)
6
LAND MOBILE ALERT
The Land Mobile Alert functionality uses the Distress channel in the Inmarsat-C
system. It is therefore very important that the LES has been configured correctly
before using this functionality.
6.1
Land Mobile Alert Routing
In order to enable the Land Mobile Alert feature at the LES contact the LESO and
inform them about which mobile numbers you intend to use for Land Mobile Alert and
inform them to which address you want the alerts to be routed.
The types of destination addresses available are:
E-MAIL, TELEX, ISDN/PSTN-MODEM, PSTN/ISDN FAX and X.25.
The most common is to route the Land Mobile Alerts to the Fleet Tracking software
or your control centre.
6.2
Land Mobile Alert Configuration
In order to enable the Land Mobile Alert feature in the easyTrack some configuration
needs to be done using Terminal Mode in easyMail.
To enable the Land Mobile Alert function in the easyTrack type following command:
Se –k 1<return>
1) To disable Land Mobile Alert function in the easyTrack type following command:
Se –k 0<return>
Use following command to set up which LESes to use for the Land Mobile Alerts in
each Ocean region:
Se –m <aorw-les no>,<aore-les no>,<por-les no>,<ior-les no>
For instance:
Se –m 004,104,0,304
Where Pacific Ocean region LES No. is set to 0 (zero) because it is unused in this
example.
To view the setting type:
Se –m ALL_OCEANS
Which for instance can show the below:
LES IDs : 4, 104, 0, 304
For further detailed information about Land Mobile Alert configuration refer to
TT3026L/M easyTrack Transceiver Software Interface Reference Manual (TT-98-
116080)
