Thorne & Derrick Cembre B1300-UC, Эксплуатация и обслуживание

Страница: 13 / 59

13
ENGLISH
5. CRIMPING OF CONNECTORS USING THE CIRCULAR OR HEXAGONAL COMPRESSION
SYSTEM (
Ref. to Figs. 4, 5)
5.1) Connector crimping
Fit upper adaptor AU130-C into the head (see § 6.1).
Select the appropriate die set for the connector to be
crimped.
Insert die set into the head (see § 6.3).
Insert the conductor into the connector.
Position the connector between the dies and ensure the
correct location of the crimp.
To crimp connector continue as § 2.2.
NOTE: when more compression is
required, proceed according to the
sequence and direction indicated in
the fi gure, uniformly spacing the
compressions.
6. ACCESSORIES ASSEMBLY/REMOVING
When introducing or changing accessories, the battery must fi rst be removed from the tool.
6.2) Upper adaptors
(Ref. to Figs. 3, 5)
Insert the adaptor in the guides on the U-fork (33) until securely located, with the
grooves on the adaptor corresponding to the locators (06) on the U-fork head (10).
Remove the adaptor by pushing it off the locators and sliding from the head.
6.2) Lower adaptor and Indentors
(Ref. to Fig. 3)
To insert AC130-P lower adaptor or indentor PS.../E press release botton (04) and insert them
into the seat on the ram (14) until secured by the die retaining pin (02).
To ease this operation, operate the tool to advance the ram (14) 8-10 mm (0.3 - 0.4 in.)
To remove, press the release button (04).
6.3) Semicircular slotted dies
(Ref. to Fig. 5)
Press release botton (08) and insert the upper die (88) into the AU130-C adaptor (09) until secured
by the die retaining pin (07).
To remove the upper die, press the release button (08).
Press release botton (04) and insert the lower die (89) into the seat on the ram (14) until secured
by the die retaining pin (02).
To ease this operation, operate the tool to advance the ram (14) 8-10 mm (0.3 - 0.4 in.)
To remove the lower die, press the release button (04).
1 2
1 2
2 1
terminal
connector
conduc
tor
conduc
tor
Connector