THORLABS OTM211, Руководство пользователя

Страница: 10 / 18

OTM211 Chapter 4: Operation
Rev A, October 7, 2015
Page 10
Chapter 4 Operation
4.1. Starting the System
To power up the OTM211 system, follow the steps below.
1. Start the Power Supply Module by placing the POWER switch on the back of the unit to the “I” position.
Verify that the “POWER ON” indicator turns green on the lower front side of the unit.
2. At this time, the “Power” and “Ready” indicators on the Electronics Control Module will turn on.
3. Turn the key switch on the Electronics Module to the “ON” position.
4. Check the emergency stop button and make sure it is in the “Enable” position.
5. Make sure all interlocks are closed.
4.2. Graphical User Interface
The OTM211 system comes with a pre-installed software which contains everything needed for system control and
data acquisition. In addition an SDK is provided to allow users to easily create applications optimized for their
particular requirements.
The GUI has five main areas:
 The Camera Display
 The Laser Control
 The Stage Control
 The Trap Control

Tools
Figure 7 OTM211 Software User Interface