THORLABS MX40G Series, Руководство пользователя

Страница: 11 / 44

MX40G, MX70G Series of E-O Converters Chapter 3: Quick Start Guide
Rev. E, March 19, 2019 Page 7
Chapter 3 Quick Start Guide
3.1 Hardware Set Up
For first use, plug the main power cable into the rear panel connector, and then plug the other end into an AC wall
receptacle. Flip the power switch on the rear panel to the ON (I) position. The unit will now be in the “Standby” mode,
and the front panel standby button should glow amber.
Figure 4 Power Cable Port, Fuse, and Power
Switch
Figure 5 Indicator Glows Amber when Converter is
In Standby
Attach the PM loop-back fiber optic cable between the Laser Out and Laser In FC connectors on the front panel. Be sure to
clean both ends of the fiber as described in the Maintenance Section of this manual.
Figure 6 PM Loopback Fiber Cable Installed
Insert the key into the interlock switch and turn it towards the unlock symbol ( ). This allows the laser to be turned on, but the
LASER ON indicator will not glow green until the laser is actually turned on by the touchscreen button. Turn on the unit by
pressing the amber standby button on the front panel which will then turn green to indicate the unit is fully on. The touchscreen
display will come up with a boot screen for about 5 seconds and then go to the home page. The unit will initialize in the factory
default state with all functions OFF.
Figure 7 Interlock Key Switch
Figure 8 Indicator Glows Green when Converter is
Fully Enabled