THORLABS MX10C, Руководство пользователя

Страница: 15 / 40

MX10C, MX40C Series of Optical Transmitters Chapter 3: Quick Start Guide
Rev. F, February 21, 2020 Page 11
3.5 Quick Start
The following steps summarize the setup procedure required to operate the MX10C and MX40C series in the standard mode.
Please refer to previous sections in this chapter and the expanded operating instructions in Chapter 4 for additional information.
1. Turn on power to the MX10C or MX40C series transmitter via the power switch on the back panel (Figure 4).
2. Press and hold the button on the front panel until the indicator light changes from amber to green (Figure 4 and Figure 8)
3. Turn the key switch to unlock (Figure 8).
4. Turn the laser on by tapping the lower-left touchscreen button on the Home page (Figure 10). Use the utility menu page to
adjust the calibration wavelength if desired (Section 3.3).
5. Take note of the output power, which is shown in the center right section of the Home page (Figure 10).
6. Turn on the VOA controller to adjust output power, if desired, by tapping the center-left touchscreen button on the Home
page (Figure 10 and Section 4.3).
7. Turn on the AMP controller to set desired swing level (Figure 10 and Section 4.2).
8. Apply the input RF signal to the female SMA connector(s) on the front panel (Figure 5), noting the specified limits for limiting
response (Section 5.4). If an input is unused, it must be terminated with one of the included 50-Ohm loads.