THORLABS LDM1550, Руководство пользователя

Страница: 7 / 15

LDM Series Laser Diode Modules Chapter 4: Operation
Page 5 Rev G, September 18, 2017
Chapter 4 Operation
CAUTION!
Always observe proper Laser safety when operating this unit.
4.1. Normal Operation and Use
The unit should be located on a solid, dry working surface. If preferred, the unit
can be secured to a standard optical breadboard using Thorlabs C1502, C1503,
or VC3 V-groove mounts. For best performance, the unit should be oriented with
its vent holes and cooling slots facing up.
1. If not already done, move the output shutter lever to the CLOSED position.
Figure 1 Front View of LDM
2. With the key-lock switch set to the 0 (Off) position, connect the power supply
to the LDM by plugging the DC Jack into the DC IN socket on the end cap
of the module. Plug the AC connector of the power supply into a suitable
mains socket.
3. Make sure the interlock shorting screw is in place. If using a remote
interlock, see the next section for instructions on how to set up the remote
interlock.
Shutter Control
Knob
Laser Aperture