Doc 2136-D01 Rev E 1/24/02
1-4
1-4
1.3
Ordering codes and accessories
The LDC500-CAB Interface Cable, a grounding contact type line cord, and the LDC500 Operating Manual are
included with the LDC 500 (line cords for the LDC500-EC version are sold separately). The chart below shows the
ordering codes of the units and the accessories currently available.
Ordering-code
Short description
LDC 500
Laser diode controller, current range 0 ... 100 mA / 2.5 V
Ultra Low Noise
laser diode heads for different laser diode packages:
TCLDM9
Temperature controlled laser diode head for 5.6mm and 9mm laser packages with RF
modulation input. Includes built-in mounts for collimating optics and Thorlabs cage plate
accessories that support a variety of mounting configurations.
TCLDM3
Same as TCLDM9 but for TO-3 laser packages.
Shielded cable:
LDC500-CAB
Cable to connect the laser diode controller LDC 500 to a TCLDM9 or TCLDM3 Laser
Diode Head
1.4
Safety instructions
It is important to read this chapter before initial operation to avoid device and connected circuit damage as well as
endangering operators. These safety instructions must be adhered to strictly.
Only use the original line cord with grounding-contact type plug to connect the unit to the line. The unit is grounded
via the ground conductor. To avoid electric shock hazard, the plug of the line cord must be connected to a correctly
grounded power outlet. Grounding of the unit by the ground conductor of the line cord is necessary for safe
operation. An interrupt of the ground conductor may cause extreme danger and injuries to persons by electric shock.
To ensure safe operation of the unit, always keep the ventilating louvers on both sides and on the rear of the unit free
from obstruction of air flow.
The unit must not be operated in the presence of flammable gases or fumes.
The unit must not be opened during operation. Internal adjustment and replacement of parts must be done by
qualified service personnel only. Parts must not be replaced during operation. Under certain conditions, dangerous
voltages may exist even when the unit is disconnected from the line.
Attention:
All statements regarding safety of operation and technical data in this manual are only valid if
the operation is carried through correctly. All connections to the load have to be made with
shielded cables (unless noted otherwise). Thorlabs must consent in writing to any changes done
to any components or to using components not provided by Thorlabs.
Mobile telephones and walky-talkies must not be used within the reach of three meters near this
unit since the field intensities produced by this radio equipment then exceed the maximum
allowed level per EN 50 082-1.
