52
HA0362T Rev C Jan 2017
Chapter 6
Continuous
- the motor continues to move until the jog signal is removed (i.e. jog
button is released).
Stopping
- the way in which the jog motion stops when the demand is removed.
Immediate
- the motor stops quickly, in a non-profiled manner
Profiled
- the motor stops in a profiled manner using the jog Velocity Profile
parameters set above.
Step Distance
- The distance to move when a jog command is initiated. The step size
is specified in real world units (mm or degrees dependent upon the stage).
Backlash Correction
- The system compensates for lead screw backlash during
reverse direction moves, by moving passed the demanded position by a specified
amount, and then reversing. This ensures that positions are always approached in a
forward direction. The Backlash Correction Distance is specified in real world units
(millimeters or degrees). To remove backlash correction, this value should be set to
zero.
Position Profiling
To prevent the motor from stalling, it must be ramped up gradually to its maximum
velocity. Certain limits to velocity and acceleration result from the torque and speed
limits of the motor, and the inertia and friction of the parts it drives.
The system incorporates a trajectory generator, which performs calculations to
determine the instantaneous position, velocity and acceleration of each axis at any
given moment. During a motion profile, these values will change continuously. Once
the move is complete, these parameters will then remain unchanged until the next
move begins.
The specific move profile created by the system depends on several factors, such as
the profile mode and profile parameters presently selected, and other conditions such
as whether a motion stop has been requested.
Bow Index
– This field is used to set the profile mode to either Trapezoidal or S-curve.
A
Bow Index
of ‘0’ selects a trapezoidal profile. An index value of ‘1’ to ‘18’ selects an
S-curve profile.
In either case, the velocity and acceleration of the profile are specified
using the
Velocity Profile
parameters on the
Moves/Jogs tab.
The
Trapezoidal
profile is a standard, symmetrical acceleration/deceleration motion
curve, in which the start velocity is always zero. This profile is selected when the
Bow
Index
field is set to ‘0’.
In a typical trapezoidal velocity profile, (see Fig. 6.4.), the stage is ramped at
acceleration ‘
a’
to a maximum velocity ‘
v’
. As the destination is approached, the stage
