17
en
A cycle that is underway can only be modified if it has been running for a short time. Otherwise, the
detergent may have already been used, and the appliance may have already drained the wash
water. If this is the case, the detergent dispenser must be refilled (see the paragraph entitled,
"Loading the Detergent").
When the buzzer constantly beeps six times, the “End” light will turn on and the cycle has finished. Turn off
the appliance using the ON-OFF button, turn off the water supply and open the door of the dishwasher.
Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while
they are still hot and more susceptible to breakage. They will also dry better.
Cancelling or modifying a wash cycle setting...
At the end of the wash cycle...
Rotate the knob to the mark of “Reset” then select
right programme.
Wash Cycle Adjustment Buttons
Pots & Pans Button
This button (see "Close-up View - Control Panel " on page 1,letter "A",when press with Intensive wash
cycle and normal wash cycle make it possible to add a rinse wash. you can use the button to wash very
dirty pots and pans.
Half load Button
This button (see "Close-up View - Control Panel", letter "B" ) makes it possible to wash dishes using only
the upper rack if there are not enough dishes for a full load. This will allow you to save on water and
electricity.
It can be used before setting any of the wash cycles. Please keep in mind that the amount of detergent
should also be cut in half.
"ECO" Button
This button (see "Close-up View - Control Panel", letter "C" ) is used for normal dirty dishes, pots and
pans.
