THOR Jayco NORTH POINT 2021, Руководство пользователя

Страница: 97 / 209

95
Section 6: Electrical System
Rotating the tires:
TPMS Sensor batteries
Batteries used in the TPMS sensors are CR1632.
There is a small bag of parts that comes with the
sensors. Parts include a wrench, 6 nuts, 6 large
O-rings, 6 small O-rings, and a black handle tool
used to open the TPMS sensors ( A ).
The black handle tool has serrations that match up
to the bottom side of the sensor ( B ).
Place the sensor in the handle tool as shown ( C ).
The sensor will unscrew as shown allowing ac-
cess to the battery inside ( D ).
The battery “+” side faces upwards in the holder.
To remove the battery, you must
carefully lift a tab that holds
the battery in place around the battery edge ( E – circled).
The battery will slide out from under this tab.
•
TPMS sensors – DO NOT MOVE WITH THE TIRES!
•
The TPMS sensor on the front tire (on either side of the trailer) STAYS at
the front tire position when rotating tires.
• The TPMS sensor on the middle tire (on either side of a 3 axle trailer)
STAYS at the middle tire position when rotating tires.
• The TPMS sensor on the rear tire (on either side of the trailer)
STAYS
at the rear tire position when rotating tires (on both dual and triple axle
trailers).
•
This guarantees tire pressures displayed on the touchscreen are accurate-
ly showing the correct tire locations on the trailer.
NOTE: The large O-rings are replacements for the one inside the TPMS
sensor (E arrow). The small O-rings are replacements for the small O-ring
located inside the valve stem cap.