THOR GL169-N, Инструкция по установке и эксплуатации

Страница: 7 / 28

7
4. Position the equipment in its approximate working location, then install the feet or gas stand
provided.
5. Any gas burning appliance requires adequate clearance and ventilation for optimum and
trouble-free operation. The minimum installation clearances shown are to be adhered to.
6. Do not put the equipment in an area where the equipment’s flue may be obstructed. Also, do
not directly connect the equipment’s flue to any ventilation equipment or system.
Clearances
NOTE: Only non-combustible materials can be used in close proximity to this equipment.
Combustible Surface Non Combustible Surface
Left / Right Hand Side
Rear
250mm
250mm
0mm
0mm
NOTE:
This Gas Hob is supplied with adjustable stand/feet to enable the appliance to be positioned
securely and level. The installation of the gas stand should be carried out before the
completion of the gas connection.
Install the gas stand D.
1. Remove the Stand from the packaging, ensuring that all protective packaging, plastic and
residues are cleaned from its surfaces. Layout all components of the stand on the floor ready
for assembly. An allen key and a set of allen bolts are provided on the gas stand package.
2. For initial installation, remove trivets, upturn and support your gas equipment, taking care as
items may be heavy. Screw the stand support assembly into the gas equipment.
3. Slot the base plate assembly into the stand support. It should be installed six inches (6”)
from the bottom.
4. Fix and tighten the screws of the base assembly.
5. Locate the equipment into its final operating position. Then, using a sprit level, adjust the
adjustable feet to the correct level and height. Then, install the flue and trivets.
Adjustable feet
Base plate assembly
6”