THOR GE756-N, Инструкция по установке и эксплуатации

Страница: 12 / 20

10
Cleaning and Maintenance
CAUTION:
Always turn off the gas supply before cleaning.
This appliance is not water proof.
Do not use water jet spray to clean this appliance.
GENERAL
Clean the Gas Hot Plate regularly. A clean Gas Hot Plate looks better, will last longer and will
perform better. Carbonised grease on the surface or between the trivets, will hinder the transfer of
heat from the cooking surface to the food. This will result in loss of cooking efficiency.
DO NOT use water on the trivets, burners while these items are still hot as warping and cracking may
occur. Allow these items to cool down and then remove for cleaning.
The entire trivets burner can be dismantled for cleaning.
NOTE:
• DO NOT use abrasive detergents, strong solvents or caustic detergents as they could corrode or
damage the Gas Hot Plate.
• In order to prevent the forming of rust on the trivets, and burners, ensure that any detergent or
cleaning material has been completely removed after each cleaning.
DAILY CLEANING
1. The drip tray should be checked and emptied frequently to prevent overflow and spillage.
Remove the drip tray while still warm so that the grease is in a liquid state. Empty any grease
from the trays and wash thoroughly in the same manner as any cooking utensil.
2. Remove the burner, the trivets and thoroughly clean the splash back, interior and exterior
surfaces of the range with hot water, a detergent solution and a soft scrubbing brush.
3. Dry the Gas Hot Plate thoroughly with a dry cloth and polish with a soft dry cloth.
NOTE:
• If the Hot Plate usage is very high, we recommend that the weekly cleaning procedure is carried out
on a more frequent basis.
• Ensure that protective gloves are worn during the cleaning process.
• DO NOT use harsh abrasive detergents, strong solvents or caustic detergents as they will damage
the grate and burners.
• Allow these items castings to cool and remove for cleaning.
• Parts protected by the manufacturer or his agent are not to be adjusted by the installer, unless the
installer is an authorized service agent.
Periodic Maintenance
NOTE: All maintenance operations should only be carried out by a qualified service person.
To achieve the best results cleaning must be regular and thorough and all controls and mechanical parts
should be checked and adjusted periodically by a qualified service person. If any small faults occur, have
them attended to promptly. Don't wait until they cause a complete breakdown.