Thor Kitchen TMD2401, Руководство по установке

Страница: 5 / 12

ANTI-TIP BLOCK
NORMAL INSTALLATION STEPS
ANTI-TIP BLOCK INSTALLATION INSTRUCTIONS
• To reduce the risk of tipping of the drawer, the Anti-Tip
block must be properly installed located 14-13/16" above
the floor on which the appliance will sit. The 6" Anti-Tip
block must be provided by the installer. See figure 1 and 3.
The Anti-Tip block prevents serious injury that might result
from spilled hot liquids.
• If the Drawer Microwave is ever moved to a different loca-
tion, the Anti-Tip block must also be moved and installed.
When installed to the wall, make sure that the screws
completely penetrate the dry wall and are secured in wood
or metal so that the block is totally stable. When fastening,
be sure that the screws do not penetrate electrical wiring
or plumbing.
6"
(152.4 mm)
3 1/2"
(89 mm)
Anti-Tip block
FIGURE 3
ELECTRICAL OUTLET
The electrical requirements are a 120 volt 60 Hz, AC only, 15
amp. or more protected electrical supply. It is recommended
that a separate circuit serving only this appliance be provided.
The Drawer Microwave is equipped with a 3-prong grounding
plug. It must be plugged into a wall receptacle that is properly
installed and grounded. Should you only have a 2-prong outlet,
have a qualified electrician install a correct wall receptacle.
Note: If you have any questions about the grounding or elec-
trical instructions, consult a qualified electrician or service
person.
* Can also be installed using an electrical outlet in an adjacent
cabinet within the area where the provided electrical cord
can reach.
Always check electrical codes for requirements.
4"
(101.6 mm)
5" (127 mm)
Suggested electrical
outlet location*
FIGURE 4
INSTALLATION GUIDE
5 E