36
Installing and charging the batteries
1.
Insert the plug of the supplied adapter to the back of the telephone base and
the other end into an electrical outlet.
2.
Plug the telephone line cord to the back of the telephone base and the other
end into a telephone wall jack.
3.
Insert the rechargeable Ni-MH batteries supplied into the handset by following
the correct polarity as indicated. Close the battery compartment.
4.
Place the handset on the telephone base and let the batteries charge for 12
hours before using it for the first time.
Low battery warning
When the batteries are very low,
flashes on the handset screen and a
warning beep will sound every minute to prompt you to recharge the batteries.
Battery performance
When fully charged, the batteries offer approximately 8 hours of talk time and 120
hours of standby time under ideal conditions. Please note that a new battery
reaches its full capacity after several days of normal use.
The battery capacity decreases over time, reducing the talk time and standby
time. Replace the batteries if necessary.
The batteries and the handset will become hot during charging. This is normal.
Tip
When you are not using your handset, place it on the charger so that you can
always have fully charged batteries.
WARNING
DO NOT USE STANDARD OR ALKALINE BATTERIES. THEY MAY EXPLODE AND CAUSE
INJURY. ONLY USE RECHARGEABLE NI-MH BATTERIES AS INDICATED IN THIS USER
MANUAL.
Risk of explosion if you use incompatible batteries
Never use non-rechargeable batteries. Use only batteries that are identical to the
Telephone Jack
Adapter Jack
