THOMSON ST716v5, Инструкция по установке и настройке

Страница: 21 / 52

E-DOC-CTC-20060911-0057 v1.0
Chapter 2
Basic Installation
15
Finishing the Home Install Wizard
The Home Install Wizard will configure the Thomson Gateway and your computer according to the service
profile. Proceed as follows:
1 You can follow the configuration progress in following window:
2 Click Finish to close the wizard.
The following steps will happen automatically:
„
After some seconds, the PPP LED on your Thomson Gateway will be lit green to indicate Internet
connectivity. If not, refer to
“4.2 LED Diagnostics” on page 33 . If needed, you can test your Internet
connection as described in “ Testing your Internet Connection” on page 35 .
„
The CD Menu is displayed. See “2.3 The Setup CD” on page 18 for more information.
„
You are redirected to the embedded Thomson Gateway pages automatically (unless you cleared the
http://dsldevice.lan check box in the last window of the Home Install Wizard). These pages allow you
to configure the Thomson Gateway firewall, Thomson Gateway settings, your wireless access point
settings, and so on. See the User’s Guide for more information.
More on IP settings
In most cases, the computer’s networking interface used during the Home Install Wizard procedure will be
configured for obtaining its IP configuration dynamically. This is the most convenient configuration and
should not be changed.
i
For fixed or advanced IP configurations, please follow the instructions of your ISP.