EN
2
3 - Programming the remote control
Method A – Fast programming with 1-digit subcode
Method B – 3-digit codes programming
Before you start programming, you must find the subcode of the set to be controlled
(television set, video recorder or satellite receiver).
Refer to the list provided with these instructions, page I of the subcodes.
1. Switch on the set you want to control.
2. Hold down the key SETUP/SHIFT (20) until the red indicator lamp (12) remains
lit (the indicator lamp remains on for a couple of seconds, so that you have time
enough to proceed with steps 3 to 6. The indicator lamp flashes to signal that this
time is almost up, and then goes off).
3. Select the set to be controlled:
TV
(4): television set, VCR (3): video recorder, SAT (5): satellite receiver
4. While the indicator is lit, type in the subcode (example: 1 for THOMSON).
5. Direct the remote control towards the set and try to switch it off by pressing the key
B
B
(1).
6. Immediately upon the switching-off of the set to be controlled, press MUTE/OK (10)
to store the subcode.
7. Should the set not switch off, press key
B
B
(1) repeatedly, until the set switches off.
Between two subsequent key depressions, give the red indicator lamp (12) enough
time to extinguish and light up again (about 1 second). Proceeding this way will
enable you to see whether the set responds or not.
8. Immediately upon the switching-off of the set to be controlled, press MUTE/OK (10)
to store the subcode.
Check of the programming
In principle, your set is ready for receiving the remote control commands.
Check your remote control for proper functioning by performing the test described on
page 4.
Before you start programming, you must find the code of the set to be controlled
(television set, video recorder or satellite receiver).
Refer to the list provided with these instructions, page II of the codes.
1. Switch on the set you want to control.
2. Hold down the key SETUP/SHIFT (20) until the red indicator lamp (12) remains
lit. The indicator lamp remains on for a couple of seconds, so that you have time
enough to proceed with step 3. The indicator lamp flashes to signal that this time is
almost up, and then goes off.
3. Select the set to be controlled:
TV
(4): television set, VCR (3): video recorder, SAT (5): satellite receiver
4. While the indicator is lit, enter the first digit of the 3-digit code proposed for the set
to be controlled (example: 016 for THOMSON). The red indicator then goes off or
flashes, if the code is not on the list.
5. Direct the remote control towards the set and try to switch it off by pressing the key
B
B
(1).
6. Should the set not switch off, repeat step 2. Then type in the next 3-digit code. Try to
switch off the set by pressing key
B
B
(1) once. Repeat this procedure by trying out
each of the 3-digit codes.
Check of the programming
In principle, your set is ready for receiving the remote control commands.
Check your remote control for proper functioning by performing the test described on
page 4.
+
+
+
ROC 40-16L 25/02/02 15:15 Page 2
Содержание ROC 40
Страница 1: ...COV1 40 28 03 00 11 42 Page 1 ...
