Chapter 1: Connections and Setup
4
ON
ON
ON
ON
X
DS Channel Bonding (BLUE LEDs)
ON
ON
ON
ON
X
US Channel Bonding (BLUE LEDs)
ON
FLASH
ON
ON
X
Installation 3.0
DS Partial service
US Channel bonding
ON
ON
FLASH
ON
X
Installation D3.0
US Partial service
DS channel bonding
ON
FLASH FLASH
ON
X
Installation D3.0
DS & US Partial service
ON
ON
ON
ON
X
No US/DS Channel Bonding but Registered with D30 mode
CPE
Operation
X
X
X
X
OFF
ON/
ON
FLASH
OFF: No Ethernet Link
ON: Ethernet Link, if connect to Giga port will be lit blue
FLASH: TX/RX Ethernet Traffic
Note:
the color of this LED will be Blue if it's linked to Gigabit
SW Download
Operation
ON
FLASH
FLASH
ON
X
A software download and while updating the FLASH memory
Reset Button behavior
a)
Push and hold the button between 0 and 5 seconds
Reboot the device
b)
Between 6 and 10 seconds
Display the channel bonding status for DS and US
Note
: This is the same as the above Channel Bonding display after the registration
c)
After 11 seconds
Perform the factory reset (This operation should only be performed upon your
Cable-Operator’s request)
