- Version du 18/06/2020 -
Adapt’matic cross bar and lid: User’s Guide
6/7
The cross bar is 800 mm long; if needed, the ends can be cut off with a metal saw. In
this case, cut the same length on each side.
Take out the manual cross bar with two 17-size wrenches.
Place the motor axis (1) and the pin (2), turn the cage until the two elements engage.
Replace and tighten the (B) bolts.
In both cases, if the pin is too high or low for to be engaged by the motor, screw or
unscrew the bolt underneath the extractor.
Extraction
Connect to the electrical supply.
Open the transparent lid.
Place the uncapped frames vertically in the cage, taking care to balance the load, and
putting the heels outwards.
Close the lid. The "click" of the safety device must be audible when closing (and
opening) the lid.
Press the ON/OFF switch (8).
Turn the speed variator in slow gear (medium for tangential extraction) in the chosen
direction et wait a couple minutes before raising the speed.
Once the extraction is completed, put the lever (9) back to 0 and wait for the complete
stop of the cage.
Press the ON/OFF switch to stop the machine.
Collect the extracted frames
NOTE
: Opening the lid during the cycle stops the motor.
MAINTENANCE
CAUTION
: Protect the motor when washing with water.
Store preferably in a dry place.
