TA04583 B Page 3 of 8
2.0
INSTRUCTIONS FOR USE
The tool is supplied with the batteries completely discharged;
before use, fully charge the batteries using the charger supplied.
See section 3.0
The tool can be easily carried using either the handle or wrist
strap, see Fig. 1.
W
ith the tool at rest, and the ram fully retracted proceed
as follows:
• Select the appropriate groove or die set for the connector.
(Ref: Check Thomas & Betts instruction sheet for the
connector and make sure die code matches die code of
connector.)
• If using ‘W’ dies refer to section 2.5.
•
Insert the conductor in the connector.
•
Position the connector between the groove or dies and
ensure
the correct location of the crimp. (See connector(s)
instruction sheet for number of crimps.)
PREPARATION
(Refer to Figs 1, 2 & 3)
2.1
•
Press the operating button (3) to activate the motor-
pump and advance the ram. To halt the advancement,
release the operating button (3) and the motor will stop.
Make sure the dies are exactly positioned on desired
crimp point, otherwise reopen dies following instructions
as per Step 2.4 and reposition the connector.
DIE ADVANCEMENT
(Refer to Fig. 3)
2.2
Fig. 2
COMPRESSION
(Refer to Fig. 3)
2.3
•
Continue pressing the operating button (3), the ram will
gradually move forward until the tool jaws touch.
•
Continue tool operation until the maximum pressure
relief valve is activated and a “click” is heard.
•
The tool jaws will automatically open as the ram is fully
retracted. To interrupt automatic retraction of the ram,
quickly press the operating button (3).
•
By pressing the pressure release button (8) , the ram will
retract and open the tool jaws.
RELEASE OF DIES
(Refer to Fig. 3)
2.4
• Press pins (2) and insert “W” dies into their seats in the
tool jaws.
•
To remove, simply press pins (2) and slip dies from the
tool jaws.
USING “W” STYLE DIES
2.5
Fig. 3
WARNING
When operating the tool never place hands or other body
parts between the crimping dies or tool jaws.
•
Ensure the ram is fully retracted.
•
Push and turn the locking pin (9) clockwise so that it
slides out and disengages from the jaw assembly.
•
Slide the jaw assembly out from the top
of the tool.
•
Insert replacement jaws into the tool and
push the locking pin back into the tool
and jaws.
•
Make sure the pin locks by turning it
clockwise until the red index marks are
aligned.
TOOL JAW REPLACEMENT
2.6
(Refer to Fig. 4)
2
2
9
Red Lines
Fig. 4
8
3
“W” Style Dies