T H M
C L A V I C U L A X C
E
20
LOREM
IPSUM
ASSEMBLY
-
Screw the adjusting screw
(1)
into the
axle
–
use the THM adjustment tool, or
a 6 mm Allen key for this.
tighten = screw counterclockwise!
loosen = screw clockwise!
-
Tighten the adjusting screw until the
collar on the cone sleeve is flush
against the bearing or spacer ring.
The tightening torque required for
this is typically 5
–
10 Nm (44
–
106lbf·in)
–
depending on the actual
width of the bottom bracket housing.
-
Check the clearance between the
cranks, chainrings and the chain
stays of the frame.
-
Minimum clearance: 3mm.
-
Remove the adjusting screw
(1)
.
-
Pull the crank arm a little off the
axle (3-5 mm).
-
Check if the cone sleeve (black) is
flush with the end of the multi
segment area (green marked line) or
up to 1.5 mm more towards the
chainring side of the crankset.
-
If the cone sleeve is not in the
position described above this can
lead to premature wear.
1
1