a
a
a
a
c
b
3.9.4 Installing the cable loop (accessory)
Choose a suitable place for installation at the back of the vehicle or on
one of the sides. You can also obtain further holders as accessories
(Item no: THA-2-00026) to use the cable loop for other areas of the vehicle.
Using the screws provided, fasten the holder of the cable loop to where you
want to place it. If you drill through the outer skin of the vehicle, seal the
drilled holes with Sikaflex to prevent the penetration of moisture.
3.9.5 Installing the central unit
Choose a suitable place for installation on the outer skin of the vehicle.
Installing on the roof provides good protection against tampering and further
security in the event of an alarm. However, the central unit is less accessible
to the user and visual acknowledgement of the switching process is not so
easy to see close-up.
When choosing the place for installation, note that the connection cable must
be laid inside the vehicle. Installing the unit above a wardrobe, for example,
would be ideal.
The base plate has four screw holes (a, Diagram 5) which can be used to
fasten the central unit to the vehicle. When using screws, make sure that no
moisture can penetrate into the wall of the vehicle. The screw holes should
be sealed over a large area with Sikaflex. If screws are not used, both places
of attachment using adhesive must be properly treated beforehand and
the central unit must be installed lengthways or with the narrow side in the
direction of motion.
If the connecting cable is fed through the roof of the vehicle without another
cable feedthrough, use the cable entry “b” (Diagram 5) and seal the opening
from underneath with Sikaflex.
If an existing feedthrough is used, use the opening “c” (Diagram 5) and the
PG gland supplied. The base of the housing has a break-out point and the
opening can be broken out using a screwdriver etc..
C.A.S. installation manual
Page 15
Diagram 5
