in
View
TM
Installation Guide and User Manual v20200824
3 |
P a g e
Installing your motorcycle transceiver for most effective engine braking functionality
In order for your
in
View
TM
Wireless Brake and Turn Signal System to provide the best passive braking functionality, the unit must be installed
securely on the motorcycle and the orientation must be set using the iOS or
Android application.
The motorcycle unit must be installed such that one of the 6 orientations
below is facing the direction of travel. For example, if you select Side 2
below, the side with the
in
View
sticker faces toward the front of the
bike. It needs to face directly forward. Any tilt or deviation other than
directly forward will diminish the functionality of passive braking.
Please note the following orientation considerations:
Orientation 1: Wires down is most effective. Wires up is least effective.
Orientation 2: Wires down is most effective. Wires up is least effective.
Orientation 3: Wires down is most effective. Wires up is least effective.
Orientation 4: Wires down is most effective. Wires up is least effective.
Orientation 5: inView™ label up is most effective. Label down is least effective.
Ori
entation 6: inView™ label up is most effective. Label down is least effective.
Note: See iOS / Android instructions for turning on beta passive deceleration functionality
Wiring Instruction for the Motorcycle Transceiver Unit
When wiring the motorcycle transceiver please remember to always test all the functions of the transceiver and ensure that
the helmet lights function properly before cutting the wire leads to length and securing the transceiver to the motorcycle.
Find a safe, secure, and dry place to mount the transceiver box. We recommend mounting it under the seat or in the
tail section if available. The clear translucent cover will allow you to see the power and signal LEDs inside the case that
tell you that you have made a proper connection. Virtual LED are also available in the in
View
TM
app.
1. Lay out the inView
TM
transceiver the way it will be installed onto your motorcycle. Review wire connections in steps 4-6
and make sure the wires are routed in such a way that they will not be pinched, cut, or exposed to direct heat or moving
parts. If a power wire is pinched, it could cause the transceiver to malfunction.
2. Once the transceiver and wires are staged, clean the proposed transceiver mounting surface with an alcohol prep pad
(included). The mounting surface should be between 45 and 85 degrees Fahrenheit to achieve the strongest bonding
results from the double-sided adhesive.
Note:
The surface area must be free of all oils, moisture, dirt and wax in order for the supplied adhesive tape to
bond and adhere to the installation surface correctly. Mount the transceiver to your selected location with the
double-sided 3M foam tape.
