Using the ThinkRF R5750 USB Console
ThinkRF R5750 Real-Time Signal Analyzer User Guide
29
Configuring the R5750 IP Address
The R5750 supports dynamic IP address allocation using DHCP, or manual IP address
configuration (via static IP address).
Caution
: If the R5750 IP address is set to a static IP, the only way to communicate with
the R5750 is via that IP address. If you mistakenly enter the wrong IP address and/or
subnet mask, or forget the IP address, you can change the IP configuration using the
USB console or by restarting the R5750.
To configure the R5750 IP address via the USB console:
1.
Open a connection to the R5750 USB console (as described above).
2.
Enter the following SCPI commands. Press “
Enter
” after each line and substitute
the appropriate IP address for your R5750 analyzer:
:SYST:COMM:LAN:CONF STATIC
:SYST:COMM:LAN:IP?
:SYST:COMM:LAN:IP <IPs address>
:SYST:COMM:LAN:GATE?
:SYST:COMM:LAN:GATE <gateway address>
:SYST:COMM:LAN:NETM?
:SYST:COMM:LAN:NETM <netmask address>
:SYST:COMM:LAN:DNS?
:SYST:COMM:LAN:DNS <DNS address>[,DNS address 2]
:SYST:COMM:LAN:APPL
