Page 11
TLX160 Matrix Switch Product Manual
thinklogical
Rev. E, February, 2018
THE PROCESSOR
– i.MX 6 QUAD (Freescale)
The Processor platform key features:
•
ARM Cortex-A9 MPCore 4 x CPU
•
Memory Interfaces
➢
64-Bit DDR3-1066
➢
SD (Memory Card Specification, v3.0 including high-capacity SDHC cards up to 32 GB.
➢
Serial NAND Flash (SPI)
➢
SATA II, 3.0 Gbps HDD
➢
EIM Bus (FPGA Parallel Bus I/F)
•
HDMI 1.4 port
•
USB 2.0 Host (2 ports)
•
UART (4 ports)
•
Gigabit Ethernet Controller (RGMII)
•
GPIO (32 bits)
•
I2C Masters (3 ports)
•
Internal 100 Megabit Ethernet Interface for Controller to Controller communications
THE NETWORK INTERFACES
The TLX160 will use up to three IP addresses.
The Primary Controller Card will use address X and
address X+100. The Secondary Controller Card will use address X+1 and it will take over address X in
the event of a failure in the primary Controller Card. These addresses are set by an internal DIP switch
(see
TLX160
DIP Switch Settings,
pg. 15).
The primary’s IP address can be set from 15 to 45. The
default subnet used by the switch is 192.168.13.xxx. Users may switch to their own subnet by
reconfiguring the switch’s network startup.
This is detailed in the document
:
Manual_H
ow_To_Change_A_TLX_Matrix_Switch’s_IP_Address
The TLX160 uses several network ports for control and status.
Port 17567 accepts commands to
control the switch.
The command API is described in the document
:
Manual_TLX_Matrix_Switch_ASCII_API_V5
There are other ports that can be read to access system configuration and operating data. The actual
data format varies by model and is described in the following sections. There are five blocks of data
available for reading.
These ports are documented in
:
Manual_TLX_Matrix_Switch_Interfaces
1.
Switch connection status
(broadcast over port 17564 every few seconds)
•
The primary CPU IP address
•
First port number in this block
•
Last port number in this block
•
'N' port number values
2.
Port settings
(UDP port 17565, matrix switch localhost only)
•
Port output level value
•
Port input enable status
•
Input port number (big-endian format)
3.
Hardware sensor status
(TCP port 17566)
•
Reserved for future use.
4.
Inventory and Power Supply Status
(TCP port 17600)
•
Card Inventory
•
Power Supply Status (internal TL use only)
•
Switch card temperature readings
5.
I/O data
(TCP ports 17601 through 17320, 1 port per I/O card)
Refer to the document:
Manual_TLX_Matrix_Switch_Interfaces
Содержание TLX160
Страница 1: ......
Страница 10: ...Page 4 TLX160 Matrix Switch Product Manual thinklogical Rev E February 2018...
