24
3)
Extend the angle bars to the required height
and then fix them in position using the 16 x M4
nuts and bolts with metal washers.
o
IMPORTANT:
The angle bars must have
an overlap of
AT LEAST 100 mm.
4)
If your cooker hood is going to be used in
extraction mode, then you should connect the
ducting hose to the ceiling adaptor at this point.
o
Fix the upper chimney section to the
hanging plate, using the 4 x self tapping screws.
o
Slide the lower chimney section onto the
angle bars and raise it until it sits just below the
upper chimney section.
o
Use the hanging hook to temporarily keep
the lower chimney section in this position, to make sure that it
does not drop down whilst fixing the main body of the hood to
the angle bars.
5)
If you are going to be using the hood in
extraction mode, you should fit the spigot for
the duct hose onto the main body of the
cooker hood, using the 4 x M4 bolts,
6)
If the glass canopy
has not been pre-
assembled by the
factory, then it
should be fixed to the
top of the main
