2/7
THAN0211_Rev.1.00_E
Copyright(C) 2016 THine Electronics, Inc.
THine Electronics, Inc.
Security E
4. Power Supply Setup
This chapter shows power supply condition.
Caution: Please check if there is no power-GND short on below red trace before supplying any power.
3.3V Power Supply to Each Board
Each evaluation board requires 3.3V power supply. Please use “CON1” connector typically.
Figure 2 THEVA1027-V2 power supply for evaluation board
Power Supply from / to Connector
3.3V power supply can be connected to CON103 and CON102 by using W101 and W102 solder jumper.
THEVA1027-V2
W101: Connect the 3.3V power supply with pin#1 and 2 of CON103.
W102: Connect the 3.3V power supply with pin#29 and 30 of CON102.
Figure 3 THEVA1027-V2 power supply from / to each connector