OPERATING INSTRUCTIONS
TM-CHAIN BLOCKS
B07725-G
EN 06.2022
7 | 12
Reeving scheme of TM-B-OP-100N:
For load chain mounting make sure that the welds of the upright load chain links in the
sprockets of the drive module and top block face outwardly!
For design reasons, at the bottom block this can only be achieved by a deflector roll.
In the case of multi-strand versions, it can happen that all load chain strands are twisted after
thechain block has been fitted correctly. This is due to the way the chain block has been stored.
Before further use of the chain block, turn the bottom block around the horizontal axis
(perpendicular to the chain wheel axis) until all load chain strands are no longer twisted.
The load chain must not be twisted between its two attachment ends!
6
INSPECTIONS
6.1
General
Inspections and maintenance must be arranged by the owner!
Inspection deadlines shall be determined by the owner!
Inspections by a competent person must be carried out regularly and at least annually, more often
in case of heavy use. For each chain block, documentation must be kept in which all inspections
and maintenance activities are to be listed.
The chain blocks must be recertified after 4 years in operation latest.
Recertification must also be carried out after repairs, which may only be carried out by an
authorised service centre. In this case, contact the service address.
Drive modul
Top block
Bottom block
Hand chain
