6
EN
FLOOR HEATER THERMOUP FLOOR/LED/LED PLUS
FLOOR HEATER THERMOUP
FLOOR/LED/LED PLUS
Power cord (1.8m)
Cord socket
Power button
Thermoelement (glass)
Aluminium base
Figure 1. Heater ThermoUp Floor/LED/LED Plus
Heater design
What’s Included in the set
1. Heater
2. Detachable electric power cord for heater
3. Control panel
4. Operating manual and warranty card
Setting a new control panel
1. Switch off the power to the heater using the button on the side
panel of the heater: when switched off, it does not glow.
2. In the upper left corner of the control panel, press and hold
the «Power on» button.
3. Turn on the power to the heater with the button on its side
panel.
4. Release the button on the control panel. The setting is
complete.
If you have replaced the remote control, the setting procedure
must be repeated.
Installation and connection
1. Unbox the device.
2. Place it on the
fl
oor or any other
fl
at surface.
3. Plug the removable power cord into the appropriate
part on the device, then plug the power cord into an
electrical outlet.
4. Press the heater power button to put the device into
operation.
5. Set the required power of the instrument using the
regulator.
Binding of remote controller with the heater is carried out
on a manufacture. If there is no heater response on the
remote controller please repeat connection procedure in
accordance with the instruction.
