ThermoSpas Executive Series, Руководство пользователя, Страница: 19 / 76

15
Executive Series
Step 10: Begin filling your spa up to 1” below the pillows. The actual water level may vary
depending on the bather load. When there are no bathers in the spa, the water must
be high enough to prevent pump surge and low enough that when the recommended
number of bathers are in the tub that the water is not overflowing out of the spa. The
recommended water level is half way up the filter area with no bathers. While spa is
filling periodically check underneath to be sure unions are tight and not leaking.
Note: Unions are located on both the spa’s water pump(s) and heater. It is imperative that they
are checked and tightened before filling the spa. Although every spa is thoroughly tested twice in
our factory during final inspection, some connections may loosen during transport from the
factory to your home.
Heat Water
Step 1: Set desired temperature by pressing the Warm ( ) or Cool ( ) button.
Step 2: Install insulated cover, close it over spa, and secure it with the lock down straps.
Step 3: Allow between 5 and 24 hours for the water to reach the desired temperature. A 240-volt
service will raise it approximately 4° to 8°F per hour.
DANGER:
RISK OF PERSONAL INJURY.
Check water temperature carefully before entering hot tub! Excessive water tempera -
ture can cause burns, welts and body temperature to rise, hyperthermia (over-heating).
Prep Water: Maintaining Correct Water Chemistry and Safety
Improper use of spa chemicals may be dangerous and could damage your spa and its cover.
Since this damage is not covered by your warranty; it is extremely important to take precautions
when using these products. Only use chemicals and cleaning agents designed for spas. Damage
resulting from the use of non-recommended chemicals and/or cleaning agents is not covered
under the warranty. Following the procedures in this guide will make the maintenance and care of
your spa simple and economical.
Avoid using any biguanide or copper-based algaecide with your spa. Use of these products is not
recommended by ThermoSpas and may void your warranty.
CAUTION: RISK OF PERSONAL INJURY OR SPA DAMAGE!
Never add chlorine tablets (trichlor) or acid to your hot tub for any reason! These chem -
icals may damage components within your hot tub, burn or irritate your skin, create a
rash, and void the manufacturer warranty for your spa.
!
!
Spa Start Up