Installation guide
Installation guide
Barrel Nº63
Barrel Nº63
BARRELS
BARRELS
STEP SEVEN
Measure steel bands (I) to ensure
correct length of 276,” +/- 1/2” is
acceptable.
Install steel bands (I) by wrapping
bands around barrel prior to
connecting with bolts and nuts (U).
Place steel bands evenly around
barrel, covering screw heads.
Measure from steel band to barrel
edge to ensure the steel band is
even.
Cover roof with roof tape.
Rub and smooth with pressure to
ensure adhesion.
Install interior aspen roof trim (O)
with 4.0 x 50 (P1) stainless steel
screws.
STEP EIGHT
Attach bench supporting leg (J1)
to the bench (J), install two sauna
benches on wall mounts using
stainless steel screws 4.2 x 70 (N1).
Hold the seat and leg assembly tight to
the sauna wall. Using a level, make sure
the bench seat is level from front
to back. This will ensure proper
placement.
Install backrests (J2) at your chosen
height using stainless steel screw
4.0 x 50 (P1).
STEP NINE
Wire raceways (V) and flooring
duckboards (L) can be used for wiring
runs, confirm specific wiring runs
needed for chosen stove.
STEP SIX
Continue placing body staves (C)
tightly on both sides of the sauna
using rubber mallet, while fixing
body staves on the front panel with
4.2 x 70 screws and rear window
panel with 4.0 x 50 screws to
prevent glass breakage.
To finish the roof top joint, use top
stave (H). Different thickness options
are provided to completely fill the gap.
N
H
R
I
O
P1
U
U
I
J2
P1
N1
J1
J
J2
N1
J1
J
N1
N1
C
.4” .6” .8”
Vent
1” 1.2”
Roof tape
Aspen
roof board
3-15/16´´
C
L
