Installation guide
Installation guide
Barrel Nº62
Barrel Nº62
BARRELS
BARRELS
STEP ONE
Place the support cradles (A)
on level site. The middle support cradle
will have no dowel. Carefully level for
better stability.
Place the center stave (B)
on wooden dowels embedded
in outer support cradles (A).
Fix the center stave (B)
with screw 4.2x70 (N).
STEP THREE
Place 6 sauna body staves (C, C1)
to each side of the center stave (B)
and fix with screws 4.2 x 70 (N).
Body staves (C)
are left and right sided.
Be sure to align the panel
groove on every next body stave.
STEP TWO
Measure support cradles (A) diagonally
from corner to corner.
Measurements “a” and “b” should be
equal to ensure the cradles are square.
Be sure cradles remain level.
STEP FOUR
Place door panel (D) in front slot.
Be sure panel is centered, leveled,
completely seated. Attach side
panels (F, F1) using 4 5.0 x 120
(M) screws and 2 4.2 x 70 (N1)
stainless steel screws.
Place rear panel (E) with bench
supports facing interior.
Confirm width of rear panel (E)
matches combined width of left
panel section (M), front panel (D)
and right panel section (M). These
panels must be completely seated
into the floor panel.
STEP FIVE
Place body staves (C) until the
halfway point. Place rear panel
with window (E1) on rear panel (E),
fix by 2 screws 5.0 x 120 (M).
A
B
A=B
N
A
B
Centered
Back
Vent
Front
C
M
E1
E
C
B
C1
N
x6 pcs
x6 pcs
D
M
M
M
F
F1
N1
N1
E
M
M
