THERMOROSSI CIAO, Руководство пользователя

Страница: 11 / 40

Pg. 11
3) Auxiliary settings button: service button necessary for programming the on-off cycles, operating levels, clock settings.
4) Auxiliary settings button: service button necessary for programming the on-off cycles, operating levels, clock settings.
5) Programming activation and deactivation button
6) “MENU” selection button: Press this button repeatedly to scroll the various regulation, setting and programming options
(see paragraphs 5.2 and subsequent paragraphs.)
7) Display
8) Infrared sensor for remote control
9) Ventilation level indicator
10) Power level indicator
5.1.2 BACK PANEL
The panel is installed on the back of the appliance and has the
following functions:
11) Main switch 0-1
12) Electrical power outlet 220-240V 50 Hz.
13) Overtemperature thermostat button cap. In the event of
overtemperature this safety thermostat stops the loading of pellets. To
restart the appliance you need to wait until it cools down, then verify
the cause for the overheating, remove the cause, unscrew the
protective cap and press the button (13) .
14) Feed motor test indicator light. The light comes on when the
pellet screw feeder is set in motion.
5.2 DAY AND TIME SETTING
The heater must be fed with the rear switch in position "1". Display (7)
may show the inscriptions On, OFF or Star.
To set the weekday and current time proceed as follows:
Press once the key (6), and the inscription Hour will flash. After a few
seconds the fixed inscription days will appear. In order to adjust the
day, repeatedly press key (4) or (3) until the led turns on in area (9)
which corresponds to the present day; Monday is indicated by the 1st
led on, Tuesday is indicated by the 2nd led on,....... Saturday is
indicated by 6th led on, while Sunday corresponds to all six leds being
on. Then confirm the day by pressing the key (1).
The two digits representing the hours will start flashing in the display: select the present hour using the arrow keys (4) or (3); the
selection must be confirmed by pressing key (1). Now the two minute digits blink; Set the current minutes by acting on the arrow
buttons (4) or (3), and confirm the selection by pressing button (1).
The setting of the day and of the hour is now completed. For the entire procedure to be confirmed and to move back to the heater
status display, key (6) must be repeatedly pressed until the operating status is displayed: On, OFF, o Star.
5.3 ON/OFF PROGRAMMING
The heater must be fed with the rear switch in position "1". Display (7) may show the inscriptions On, OFF or Star.
It is possible to carry out the weekly programming by setting up to
three on/off cycles for each day from Monday to Sunday. For the
programming proceed as follows:
• Press push button (6) until the inscription cron is on: in area (9) a
led goes on (which indicates that the first day of the week, Monday,
is being programmed).
Inscription On1 will appear on the display, and the two digits
representing the hours will turn on. Press button (3) or (4) to enter
the hour of the first cycle start time. To confirm the selection press
the button (1).
RESET RATIO MOTOR LED