2.5
REV-5
SECTION 2
© 2015 by Thermoplan AG, Subject to change
Technical Manual
•
The unit requires a cold drinking water connection.
•
The distance between the machine and the water connection should not be more than 100 cm (40 inches).
•
To connect the unit, use only the supplied original hose.
•
The water pressure must be between 2 und 4 bar (29 - 58 psi) If the water pressure is more than 4 bar (60 psi), you have
to install in a pressure reducing valve. Use an according booster pump if the net water pressure is very low or if there is no
net water pressure (water from water tank).
•
All national and regional rules and directives are to be followed. Contact an expert if you have questions.
WATER
CONNECTION
WATER QUALITY
•
The water quality has a big impact on the quality and the taste of a coffee.
•
Use a drinking water supply only!
•
The optimal total water-hardness is 5-8 dH° / 8-14 fH°. In most cases, the use of an acitve-coal filter is necessary. Contact
an expert if you have questions.
•
The distance between the water drain and the machine should not be more than 100 cm (40 inches).
•
It is important that the water drain (tube) does not hang down to allow proper draining.
•
Make sure there is no back pressure in the drain system.
WATER DRAIN
For hygenic reasons the equipment must be cleaned before the start-up.
Caution:
•
Do not clean the milk tank, bean hopper, grounds drawer or drip tray in high concentration alcohol based cleaners, such as
cleaning alcohol, ethanol, methanol or other strong detergents. Also prohibited to use for cleaning are acetic acid etc.
•
Only use comercially available detergents.
•
Do not put plastic parts, (polyamids), into microwave ovens at any time as the microvaves will affect and deteriorate the
plastic material.
•
Do not clean the machine with a jet of water.
CLEANING
Installation and putting into operation
Important indications
DISPOSAL
•
The packaging material (cardboard, plastic, styropor) must be disposed of in compliance with statutory regulations.
•
In order to avoid any accidents caused by inappropriate use, or in particular by playing children, the machine must be put
out of operation and disconnected by an authorized service agent. Subsequently cut off plug from power cord.
•
The correct disposal of the machine helps to prevent negative consequences for the environment. Dispose of the equipment
according to the local rules and regulations. The manufacturer highly recommends the recycling of old machines.
When handling electronic components, the following safety indications must be considered:
•
The tools used must be intact and approved by Thermoplan (see Technical Manual section „Tools and Accessories“).
•
The electronic components must be kept away from moisture, dust, low-resistance materials, chemicals or lipids of any kind.
•
The electronic components must be protected from electrostatic discharge at any time (ESD-packaging).
•
The workplace area must be fitted with a ESD-conform protection with a protective resistor of 1MΩ.
•
To avoid damage due to static charge, the service technician must be grounded with a protective resistor of 1MΩ when
working with electronic components.
HANDLING OF
ELECTRONIC
COMPONENTS
