Terminator
TM
DE-B Beacon
LED End of Circuit Light Kit
INSTALLATION PROCEDURES
Страница 1: ...TerminatorTM DE B Beacon LED End of Circuit Light Kit INSTALLATION PROCEDURES ...
Страница 2: ... 4 1 RTV Tube 5 1 GRW G Grommet SCTK 3TB only 6 1 IP66 Type 4X 60 C Ta 45 C T6 60 C Ta 55 C T5 Ordinary Hazardous Locations Class I Division 2 Groups A B C D Zone 2 IIC T6 T5 Class II Division 2 Groups F G Class III Certifications Approvals Installation Precautions To minimize the potential for arcing and fire caused by product damage or improper installation use ground fault protection The Nation...
Страница 3: ...d in PETK 3 6 Cut off end of cable 7 Terminate cable with appropriate SCTK termination kit Refer to SCTK installation instructions Push excess cable back through expediter Remove braid pigtail Tape cable expansion loop to pipe 8 When using wire connector Connect bus wires using small wire nuts for BSX HTSX and KSX or medium wire nuts for RSX VSX VSX HT HPT and FP When using terminal block See step...
Страница 4: ...crew cap 10 Use the terminal block mounting screw to mount terminal block to the LED light module Bend each pigtail lead around the sides of the terminal block 13 Engage threads Rotate light module cover clockwise and tighten cap securely Make sure latch mechanism is in the locked position 9 When using SCTK TB Connection Kit first trim exposed bus wires of the LED pigtail to 8 mm 32 then connect t...