DE GB
14
Preparing for installation/
Installation
Preparing for installation
The water and electricity supply need to be available at the place where the unit is to be
supplied. If the electricity cable is buried in the wall then use the supplied spacers. If the
electricity cable is fixed to the wall then the unit can also be fixed straight to the wall.
Remove the top of the housing with a cross-head screwdriver.
Unscrew the fixing screw of the cladding (ref. 1) and then remove the cladding (ref. 2).
2
Install the supplied plumbing components as illustrated.
The cold water isolation valve (stop valve) should not be used to choke the flow through
the heater.
3
4
Use two pieces of self-adhesive tape to
fix the template on the wall where the
heater is to be installed.
Drill two 6 mm holes through the template,
as indicated.
Bear in mind where the water pipes will be
installed later.
Install the unit with the supplied screws
and plugs.
Install the hot and cold water pipes and
supply cable as shown on the template.
C
M
Y
CM
MY
CY
CMY
K
pic 1.5.pdf 10-10-2011 11:54:13
