INSTALLATION – ELECTRICAL
Refer to Installation Diagram on page 2 for required hardware and General assembly. Any other installation
position may result in serious damage to the appliance. Installation should take place as close as possible
to a cold water connection.
The product should be protected from the effects of frost (For example if
installed in RVs or summer homes)
Note:
When tightening swivels and compression connections always use 2 open end wrenches in order to
prevent bending and twisting pipes and accessories.
After installing unit in accordance with step 1 above, fill the unit with water prior to connecting to a power
supply.
Connect device to electricity by inserting plug into an available wall socket. The device must be directly
connected to an outlet power supply of 120V via an electrical cable or plug.
Note:
Connection of the device to the power supply must be made in accordance with the NEC and as
specified by local laws and regulations.
When powering up for the first time, please verify that the temperature indicator light turns off when the set
temperature is reached (see operating instructions on page 4 for setting the temperature).
Note:
The device is completely filled if water flows out of the hot water tap. The device will only switch on
again if the temperatures falls below the temperature setting.
Note: When filling for the first time, the hot water handle on the faucet must be open so that water can flow
into the device. If the device is not filled with water during installation, the automatic safety device will
activate and switch off the device.
04
TM
2.6 Gallons Water Heater -
User Manual
Содержание 2.6 Gals
Страница 8: ...2 6 Gals TM...