Thermofilm Bliss euro BE1000 Скачать руководство пользователя страница 4

 

4  

 

2.3.1 Anti-Frost Function 

Turn the thermostat control knob (

2

) to “

”.  The heater will automatically switch on 

should the room temperature drop below 5°C, when the heater is in the “ I ” power 
setting.   
 
 

2.4 Timer Function 

Move the control slide switch (

5

) from “O” (POWER OFF) to “

” (TIMER ON). 

 

2.4.1 Setting the Current Time 

Turn the 24 hour manually set timer (

4

) clockwise until the “

” 

indicates the current time.  Note: this is a 24 hour time device. 
 

 For example, the “

” pointing to 8 indicates the current time 

is 8AM. 

For example, the “

” pointing to 19 indicates the current time 

is 7PM. 
 

2.4.2 Programming the 24 Hour Timer 

 
There are a total of 96 keys on the 24 hour manually set timer.  Each key represents 15 minutes. 
Note: On the left diagram, the gears are illustrated as thick black lines. 
 
If the key is set inwards (towards the centre), the heater will be set to ON during that period.  If the key is 
set outwards (away from the centre), the heater will be set to OFF during that period. 
 
Note: On the diagram above, the keys are set towards the centre, indicating that the heater will be ON for 
the full 24 hour period. 
 
Example:  The right diagram illustrates the 24 hour manual set timer is programmed to be off from 6.30AM to 
8.30AM, and 7.30PM to 10.15PM.The heater OFF times shows the keys are set outwards (away from the cen-
tre).  The heater ON times shows the keys are set inwards (towards the centre). 
 
Notes: 
If the power is switched OFF, or in the event of a power failure, the 24 
hour manually set timer function will stop functioning.  The correct time 
must be reset when the power is restored. 
The clock face turns CLOCKWISE ONLY.  Forcing the clock face in an 
anti clockwise direction will destroy the timing keys and void the product 
warranty. 
 
 

2.5  THERMOSTAT CUT OUT 

The Bliss Euro heater is equipped with a safety cut-out that switches the 
heater off if it overheats.   
Once the heater has switched off due to overheating, remove the cause 
of the fault, e. g. blocked air grids.  When the heater has cooled down for several minutes it will restart auto-
matically. If the heater then cuts off again, switch off the heater and call an authorized service person. 

 

 

Содержание Bliss euro BE1000









Отзывы: