__________________________________________________________________________________
7 |
P a g e - S e i t e
8.
Never stick needles or sharp objects (or the
like) in the product!
9.
The product should be protected against
mechanical damage by suitable coverings
(e.g. insulation and metal sheeting)
10.
In case of additional safety matters a
temperature limiting device may be
installed
to
protect
the
application
components from damage.
To prevent danger an RCD or ELCB
has to be installed!
Handling Information:
11.
Never lift or pull the heating unit by its power
cord or lead wire.
12.
Never handle the heater while in operation.
13.
When removing or maintaining the drum
heater, disconnect the power and allow the
drum heater to cool down to ambient before
handling.
14.
Select a suitable clean location below the
lowest expected content level of the drum.
15.
If the drum heater is located outside or in
an area that it may be splashed with water,
the leads, exiting from the terminal cap,
must be directed to the ground.
16.
Pull the spring to attach it to the opposite
tab shaping the drum heater tight against
the drum. (see Diagram 2)
Diagram 1: An Example of Proper and
Improper Installation
Diagram 2: Spring Assembly
Warning:
Do not use the terminal cap as a handhold
when pulling the spring!
Caution:
To avoid external touching and damage, it is
required that within the application the product
(component) has to be covered by a metal
sheeting or braid, which has to be included in
the protective arrangement of Protection Class I
(protective earth) according to VDE0100 or to
the relevant standards in your country and is to
be
taken
into
consideration.
Metallic
components coming in contact with the product
have to be incorporated in the protection
measures of Protection
Class I (protective earth). For details please refer
to the standard VDE 0100 (Germany) or the
relevant standards in your country.
Additional
to
these
instructions
special
requirements for the specific products are found
on the product label or type plate and must be
followed as well.
The products are designed at a certain
protection class. Considering that the product is
not protected against hazardous body currents,
it has to be installed in such a manner that any
risk is excluded.
In case of doubt or if necessary please contact
us. (see last page for contact information)
