Thermocet Apertura series, Инструкции по эксплуатации и монтажу

Страница: 6 / 22

Page.6
Igniting the pilot light
The gas cock and air-inlet grids should be open in order to light the gas fire.
· First ignite the pilot light by turning knob (A1) to the stop in the direction of position . Now push the
knob in and wait several seconds (gas will flow out of the pilot light burner for the ignition of the pilot
light).
· Keeping the knob pushed in, turn the knob further to the left until you hear a click (spark visible at pilot
light burner).
· When the pilot light is burning, hold the knob pushed in for a further 20 seconds.
· Release knob (A1) and check whether the pilot light continues to burn. If this is not the case, repeat the
ignition operation.
· After the ignition of the pilot light turn knob A1 round to position
Igniting the main burner
Button (B6) on the remote control (B) is used to ignite the main burner.
· The flame height has an infinitely variable adjustment, which is operated by continuing to push button
(B6).
· The flame height can be infinitely adjusted downward by pushing button (B7) until the burner is com-
pletely extinguished.
Extinguishing
Turn the main fire off completely by holding button (B7) pushed in, before extinguishing the appliance
completely.
· Now turn knob A1 to the right as far as it will go, to position
push the knob in and then turn it to
position
Warning
After extinguishing the pilot light, wait at least 5 minutes before turning the appliance on again. Do not
burn any wood or other fuel. Do not place any highly flammable articles nearby. Only install the appliance
in a well-ventilated room. The air supply to the appliance must be guaranteed at all times.
Maintenance
·
The fire can be cleaned with a soft damp cloth. The appliance should be switched off immediately if any-
thing is spilled on it. Never use an abrasive !!!
· It is recommended to have the fire inspected and cleaned by an installer before every heating season. If the
special glass is broken or cracked, have it replaced at once before you turn the fire on again.
Warning: Gas fires become hot when they are in use. Care must be exercised therefore and children and in-
valids, for example, should be kept away from burning fires. Fires must also never be placed on or against
flammable materials (curtains etc.).
3. Preparations for installing the Apertura
Remove the accessories inside the supports. Carefully take the supports out of the box, so that the appliance
comes clear. Always check all components for damage or breakage. The appliance is now ready to be in-
stalled.