Thermo Scientific Thermo Scientific Savant SpeedVac DNA120, Инструкция по эксплуатации

Страница: 6 / 16

3
A
D
B
C
3.0 OPERATION (cont’d)
ROTOR INSTALLATION. Open the lid of the rotor chamber. Carefully lower the
rotor onto the drive shaft. Secure the assembly by screwing the
retaining knob into the drive shaft above the rotor. Tighten it firmly but not
excessively. Load the rotor and close the lid. Always balance rotor loads. There
need not be a tube in each hole, but the load must be evenly
distributed.
USING THE CONTROL PANEL
A. OPERATING MODE SWITCH (see section 3.1)
AUTO Press to start a run with automatic shut-off
OFF Press to stop any run
MANUAL Press to start a run with manual shut-off
B. TIMER SELECTION SWITCH (see section 3.1)
HEATER Press to select Heater timer
RUN Press to select Run timer
C. CHANGE SETTING SWITCH (see section 3.2)
Press to increase value of timer selected by switch B
Press to decrease value of timer selected by switch B
D. DRYING RATE SWITCH (see section 3.6)
LOW Concentrator chamber at ambient temperature
MEDIUM Maintains chamber at 43°C
HIGH Maintains chamber at 65°C