Thermo Scientific SR-3000, Руководство по эксплуатации

Страница: 21 / 26

UltiMate 3000 Series:
SR-3000 Solvent Rack
Operating Instructions Page 15
2.5.2 Connecting the Solvent Reservoirs
1. Feed the solvent line through the retaining guide, which holds the tubing in place in
the reservoir, and then into the open hole in the reservoir cap.
2. Verify that an appropriate frit is installed in the filter holder:
Pump Filter Frit Part No.
SD and SDN pumps Stainless steel, porosity: 10 µm 6268.0110
BM pumps
NCS-3500RS/NCP-3200RS
PEEK, porosity: 10 µm 6268.0117
RS, BX, and AB Titanium, porosity: 10 µm 6268.0111
3. Slide the filter holder with filter frit onto the end of the solvent line. Verify that the
end of the solvent line is cut straight and is not deformed. Cut the tubing straight if
necessary. Use only the original Dionex solvent lines.
4. Place the complete assembly in the solvent reservoir.
5. Tighten the reservoir cap hand-tight. Press the retaining guide into the hole in the
reservoir cap to ensure that the solvent line is hold in place inside the reservoir.
Fig. 3: Connecting the solvent lines to the reservoir
When replacing a solvent line, remove the frit first, then the retaining guide, and then the
solvent line.
6. To connect the solvent lines to the pump, direct them through the opening in the rack.
Fig. 4: Openings in the solvent rack
7. Connect the solvent lines, for example, to the internal degasser of a LPG-3400 pump
or directly to the pump inlet. Place the solvent lines in the tubing guides ( → Fig. 2,
page 13), and then connect them to the pump.
Filter holder
with filter frit
Retaining guide