Thermo Scientific Sorvall Legend X1, Инструкция по эксплуатации

Страница: 30 / 59

4
Operation
Entering Parameters
Thermo Scientific Legend X1 / X1R 4-7
While the centrifuge is in operation, two different values can be displayed. The sample temperature
and the chamber temperature. Press the CHANGE key
to toggle between the two display modes.
AIR
When AIR is lit, the temperature inside the rotor chamber will be controlled. This setting is
recommended when using the centrifuges pretemp feature.
SAMPLE
When SAMPLE is lit, the temperature of the sample will be controlled.
To set the temperature, proceed as follows:
1. Press the TEMPERATURE key in order to open the temperature selection menu.
The display shows the messages "Temperature". Depending on the display mode setting, the value
shown corresponds either to the sample temperature or to the inside chamber temperature. Press
the CHANGE key
to toggle between the two modes.
2. Enter the desired temperature using the numeric pad.
The digits show in sequential order.
3. Confirm your entry by pressing ENTER .
Your entry will be automatically confirmed if you do not press any key for 5 seconds.
Prewarming or precooling the centrifuge
For setting the pretemp value for the centrifuge proceed as follows:
1. Hold down the TEMPERATURE key for a minimum of three seconds to open the
temperature selection menu.
The display shows the message "Set PreTemp"and the current temperature inside the rotor
chamber..
2. Enter the desired temperature using the numeric pad.
The digits show in sequential order.
3. Confirm your entry by pressing ENTER .
Your entry will be automatically confirmed if you do not press any key for 5 seconds. The display
shows: