Thermo Scientific
4
S.U.B. TK Resistive Quick Start Guide
Quick Start Guide
NOTE:
Before connecting cables, route them through the tubing and
cable organizer first
• If you intend to use the Finesse TruFluor single-use sensors, route
the appropriate cables from the Tower into the cable management
arm and down to the sensor window area on the S.U.B. These
cables will already be attached to the rear of the Control Tower
via a liquid tight connection and have the following designation,
DO-2 and pH-2 (No color code).
• If you intend to use traditional re-usable sensing probes, route the
appropriate cables in the same manner as described above for the
single-use sensors. Ensure they are plugged into the back of the
control tower (
●
DO-1
●
,
●
pH-1
●
).
• Locate the bag pressure sensor cable on the Tower (
●
● ●
) and
route it via the cable management arm and up toward the top arm
of the tank.
If using a vent heater make the following connections.
• Connect cable to labeled VH-1 POWER (
● ●
) power source on
Tower.
• Connect Yellow Thermocouple to labeled connection on Tower
VH-1 FDBK (
● ●
)
• Route cable through cable management arm and up to vent heater
brackets on top of S.U.B. unit.
• If using a second vent heater, use VH-2 connections
VH-2 POWER (
● ● ●
) and VH-2 FDBK (
● ● ●
) and route
parallel with VH-1 cable.
Vent Filter Heater
If using a resistive heater make the following connections.
• Connect cable labeled RES HEATER (
● ●
●
) to the power
source on the Tower
• Connect cable labeled HEATER POWER IN (
● ●
●
) into
designated tower connector.
Resistive Heater
Power Connection
