Thermo Scientific GENESYS 10S Vis, Руководство пользователя

Страница: 76 / 134

15
Multiwavelength
Setting Up Test Parameters
68 GENESYS 10S Vis User Guide Thermo Scientific
This screen provides these capabilities:
• Setting Up Test Parameters
• Cell Correction
• Saving a Test
• Viewing the list of stored tests
• Taking Measurements
Setting Up Test Parameters
Y
To set up test parameters
In the Multiwavelength screen, highlight the desired parameter.
See the procedures below for instructions on adding or deleting wavelengths and factors.
If you have previously selected the wavelengths to measure, press Save Test to save the test or
Run Test to measure a blank or samples.
If you have not selected the wavelengths, you can add wavelengths and factors as shown
below.
Adding Wavelengths and Factors
Y To add wavelengths and factors
1. Press Set nms .
Note If Cell Correction is ON, you must run the Setup Correction application before you
can access Run Test or Measure Samples.
Note If Auto Save Data is ON, you must enter a Data File Name before you can access
Run Test or Measure Samples.
Note You can enter factors only when the measurement mode is set to
Concentration/Factor.