Thermo Scientific Dionex, Руководство оператора

Страница: 212 / 228

Dionex Integral Systems Operator’s Manual
200
Doc. 065250-06 03/2020
G.3.2 Heated Dilution Vessel Installation Procedure
1. Plug the heated dilution vessel extension cable into the connector
labeled
HEATER
on the thermal control board (see Figure G-3 ).
2. Align the notch on the rear of the
heated dilution vessel (see Figure G-5 )
with the pin on the dilution vessel
holder on the SP panel.
3. Install the heated dilution vessel
assembly onto the holder (see
Figure G-6 ).
Figure G-5. Heated Dilution Vessel
4. Plug the cable from the heated dilution vessel assembly into the
connector on the SP panel.
5. Connect the lines from the metering valve and the gas valve to the top
of the heated dilution vessel (see Figure 3-11 for the SP1 flow
schematic; see Figure 3-14 for the SP2 flow schematic).
Figure G-6. Heated Dilution Vessel Installed on SP Panel
(Vertical SP Enclosure Shown)
Notch
Dilution
Vessel Holder
Line from Gas
Valve
Line from
Metering Valve
Heated Dilution
Vessel Cable
Line from DV
Valve
1
2
3
4
5
1
2
3
4
5