Thermo Scientific Dionex AS-DV, Руководство оператора

Страница: 81 / 132

5 • Service
Doc. 065259-05 10/12
71
5. Use a 3-mm Allen wrench to
remove the set screw on the
sampling head (see
Figure 5-2 ).
Figure 5-2. Removing the Set Screw
6. Pull slightly on the sample
out line to gain a small
amount of slack in the line.
Then, slide the tubing out of
the slot in the sampling head
(see
Figure 5-3 ).
7. Push down on the sampling
head to move the needle into
the carousel a small amount.
Twist the needle to allow the
sampling tip to exit through
the opening in the sensor
block.
Figure 5-3. Sliding the Sample Out Line
Out of the Sampling Head Slot
Sampling
Head
Remove the
set screw
Slide the
line out of
the slot
Sensor Block