Environmental design standards
Reference
Description
Directive 2012/19/EU
European Union “WEEE Directive”—Waste electrical and electronic equipment
Directive 2011/65/EU
European Union “RoHS Directive”—Restriction of hazardous substances in electrical
and electronic equipment
SJ/T 11364-2014
“China RoHS” Standard—Marking for the Restricted Use of Hazardous Substances in
Electronic and Electrical Products
For instrument specific certificates, visit our customer resource page at
www.thermofisher.com/us/en/home/technical-resources/rohs-certificates.html
Electrical safety
The following information on electrical safety must be observed, failing to follow these instructions
may result in electric shock, fire and/or serious personal injury or death. In the event of an equipment
malfunction, it is the responsibility of the customer to report the need for service to Thermo Fisher
Scientific or to one of the authorized agents. For service information, contact Technical Support. See
Appendix F, “Documentation and support”.
Servicing of this device is to be performed by trained service personnel only.
• Plug the system into a properly grounded receptacle with adequate current capacity.
• Prior to switching on the product, ensure that the nominal voltage setting on the product matches
the nominal voltage of the AC supply network.
• This product should be connected to the power mains using a 3-wire (two conductors and ground)
power cable and plug. Use this power cable with a properly grounded electrical outlet to avoid
electrical shock.
• Never operate the instrument with the ground disconnected. Grounding continuity is required for
safe operation of the instrument.
• If extension cords or connector strips are implemented, they must be checked on a regular basis to
ensure that they are safe to use.
• Never use the product if the power cable is damaged. Check the power cable on a regular basis to
ensure that it is in proper operating condition. By taking appropriate safety measures and carefully
laying the power cable, you can ensure that the cable will not be damaged and that no one can be
hurt by, for example, tripping over the cable or suffering an electric shock.
• Do not insert the plug into sockets that are dusty or dirty. Insert the plug firmly and all the way into
the socket. Otherwise, sparks that result in fire and/or injuries may occur.
• Do not overload any sockets, extension cords or connector strips; doing so can cause fire or
electric shocks.
• To fully disconnect power either detach or unplug the power cord, positioning the instrument such
that the power cord is accessible.
• Ensure that the connections with information technology equipment, e.g., PCs or other industrial
computers, comply with the IEC60950-1/EN60950-1 or IEC61010-1/EN 61010-1 standards that
apply in each case.
Appendix E
Safety
Environmental design standards
E
190
CTS
™
DynaCellect
™
Magnetic Separation System User Guide
Содержание A55867
Страница 197: ......
