Safety Tips
1. Use independent power supply.
2. Check if the local power supply
voltage is suitable for use.
3. Do not drag the power supply cable
when unplugging.
4. Do not use non-specified power cable
or damage cable.
5. Service should only be performed by a
qualified professional.
6. The power supply must be unplugged
under the following situations:
(1). When the unit is moved
(2). When the electrical cabinet or the
moving component is opened
(3). When the equipment is
malfunctioning
(4). When the equipment is not in use
Maintenance
a. This instrument uses brushless DC
motor. It is maintenance free and
has a long service time, high quality,
and low noise level.
b. Surface can be cleaned with a mild
detergent and water.
Clean Spill
If accidental spillage of liquids caused by
mishandling or contained breakage
occurs on the surface of the instrument,
please shut down the instrument and
clean up the liquid immediately.
If the liquid has already spilled into the
unit, cut off the power supply first and
immediately clean up the liquid at the
surface of the instrument. Place the
instrument in a ventilated and dry
environment for 24 hours before reuse. If
the instrument is not functioning after
drying for 24 hours, please contact the
manufacturer.
Warning:
Disassembling/Assembling
without a qualified professional's
guidance may cause malfunctioning of
the instrument.
Section 5 Safety Tips and Maintenance
Section 6 Troubleshooting
Error
Cannot start
instrument,
display window
off
No shaking
of the tray
Loud noise
Cause
Power disconnected
Power switch off
Power adaptor failure
Over-weighted or
unbalanced load
Electrical malfunction
Mechanical malfunction
Tray loose
Solution
Connect the power
Switch on power
Replace power adaptor
Adjust the weight and position
of load,decrease rotation speed
Contact Thermo Scientific
Contact Thermo Scientific
Fasten screws
Other
Keep record for maintenance
11 Section 5 | Safety Tips and Maintenance
Please refer to the following table to
troubleshoot if any malfunction occurs.
If the problem still exists, contact your
local sales representative.
Microplate loose
Adjust position of the
clamp
microplate
Digital Microplate Shaker 12
Note:
Err1-Speed alarm
If Err1 occurs, please contact Thermo Scientific Customer Service for solutions.
