Thermo Neslab RTE 140, Инструкция по эксплуатации

Страница: 31 / 36

- 30 -
TABLE 1 GENERAL COMMANDS TABLE 1 GENERAL COMMANDS TABLE 1 GENERAL COMMANDS TABLE 1 GENERAL COMMANDS TABLE 1 GENERAL COMMANDS
Command Echo SEi[CR]
Echo: i = 1, No echo: i = 0 (control returns commands)
Set Setpoint SSxxx.xx[CR]
-30.00 to +150.00°C or -22.00 to +300.00°F
Read Setpoint RS[CR]
Read Main Probe Temperature RT[CR]
Read Remote Probe Temperature RR[CR]
Turn Control On or Off SOi[CR]
On: i = 1, Off: i = 0
Set Power Status Flag SWi[CR]
Set: i = 1, Reset i = 0
(reset when controller power is lost)
Read Power Status Flag RW[CR]
Read F or C Units RU[CR]
TABLE 2 ALARM COMMANDS TABLE 2 ALARM COMMANDS TABLE 2 ALARM COMMANDS TABLE 2 ALARM COMMANDS TABLE 2 ALARM COMMANDS
Set High Alarm Limit SHxxx.xx[CR]
Same range as setpoint
Read High Alarm Limit RH[CR]
Set Low Alarm Limit SLxxx.xx[CR]
Same range as setpoint
Read Low Alarm Limit RL[CR]
Read Alarm Status RF[CR]
Returns: 0 = no alarm, 1 = alarm
TABLE 3 CONTROL COMMANDS TABLE 3 CONTROL COMMANDS TABLE 3 CONTROL COMMANDS TABLE 3 CONTROL COMMANDS TABLE 3 CONTROL COMMANDS
Set Proportional Bandwidth SPxx.xx[CR]
0.10 to 10.00 % of full scale
Read Proportional Bandwidth RP[CR]
Set Integral Compensation SIxx.xx[CR]
0.00 to 10.00 repeats/minute
Read Integral Compensation RI[CR]
Set Derivative Compensation SDx.xx[CR]
0.00 to 1.00 minutes
Read Derivative Compensation Rd[CR]
Main/Remote Probe Selection Sri[CR]
Main: i = 0, Remote: i = 1
Compressor Inhibit SCi[CR]
Inhibit: i = 0, Enable: i = 1