Thermo King ThermoLite T-Series, Руководство по установке

Страница: 7 / 12

7
TEST PROCEDURE
To properly test the solar output you must have the following items:
• Halogen lamp (500W or greater) or be outdoors in the daylight
• Voltage meter
• Ammeter
1. Put voltmeter on the battery and measure the voltage.
• Voltage must be less than 12.8 V for the solar panel controller to turn on.
• If battery voltage is not less than 12.8 V then put a 12 V load on the battery.
2. If indoors, put at least a 500 W halogen lamp approximately 600 mm above the solar panel and
turn it on.
3. Put Ammeter around the positive cable from the solar panel.
• Voltage reading should begin increasing or stay the same.
• Amperage reading should be greater than 0.300 mA.
NOTE: The solar panel controller may take up to a minute to turn on. The solar panel must be
connected to the battery in order to turn on the charge controller.